Home / Home Improvement / Managing a Concrete Pump Pour

Managing a Concrete Pump Pour

By managing a concrete pump pour, you have more control over the concrete you use and can more easily access hard-to-reach areas. That is why this process is often used at construction sites. Not only do you save money, you also save time. To make sure you do not order too much concrete, insert the details for the pour and calculate the amount on the concrete supplier’s website.

Preparing for Concrete Pump Pour

To properly manage a concrete pump pour, you first need to order the concrete and pump before organising the site for such an activity. To assist you in your planning, you need to do the following:

  • Supply a safe and secure access site for setting up the pump and the truck mixer.

  • Provide a level and reliable spot to set up the pump – one that does not feature overhead obstructions.

  • Ask the supplier of the concrete in Rotherham to advise you of the consistency of the concrete for your particular project.

  • Employ a knowledgeable concreting team to lay the pumped concrete.

  • Locate a proper place for the operator to wash out the pump at the conclusion of the project. Typically, about 1/3 cubic metre of concrete remains in the pump after the operation. It is the obligation of the customer to dispose of this extra concrete.

  • Provide enough water for the operator. Even though the pump has its own water supply, it helps to supply additional water as well.

How the Operation Works

During a concrete pump pour, the operator collaborates with the site contractor before he or she sets up the pump, a pipeline (if needed), and prepares the grout. After this takes place, a mixer truck arrives at the site and backs onto the pump. The pump operator, in turn, grouts the line and starts pumping. Usually, it is considered a good work practice to pump the additional grout to waste and avoid pumping it into the pour.

Inform Your Employees of Specific Pumping Hazards

The concrete is then positioned, using a boom if needed. When a ground line is employed, the concreting team moves the pipeline, as required during the pumping. You also have to keep the following safety factor in mind since concrete is normally pumped at a high pressure. Therefore, your employees need to be cognizant of the dangers related to end hose use.

Discharging the Load

After the mixer truck discharges its load, the chutes of the mixer are cleaned before the truck leaves. Normally, the chutes are not washed into the hopper, as doing so can result in a clog and affect the quality of the pumped concrete.

The Second Half of the Process

After this initial process, the next mixer truck will arrive and back onto the concrete pump before, again, discharging its load.

About Donald Phillips

Check Also

How is a humidifier helpful for sinus problems?

Sinus is a problem that is common to half of the population that exists or …